C:\Zeit\Test\Mp3Gain\mp3gain\mp3gain.exe version 1.4.6
copyright(c) 2001-2004 by Glen Sawyer
uses mpglib, which can be found at http://www.mpg123.de
Usage: C:\Zeit\Test\Mp3Gain\mp3gain\mp3gain.exe [options] <infile> [<infile 2> .
..]
options:
        -v - show version number
        -g <i>  - apply gain i to mp3 without doing any analysis
        -l 0 <i> - apply gain i to channel 0 (left channel) of mp3
                  without doing any analysis (ONLY works for STEREO mp3s,
                  not Joint Stereo mp3s)
        -l 1 <i> - apply gain i to channel 1 (right channel) of mp3
        -r - apply Track gain automatically (all files set to equal loudness)
        -k - automatically lower Track/Album gain to not clip audio
        -a - apply Album gain automatically (files are all from the same
                      album: a single gain change is applied to all files, so
                      their loudness relative to each other remains unchanged,
                      but the average album loudness is normalized)
        -m <i> - modify suggested MP3 gain by integer i
        -d <n> - modify suggested dB gain by floating-point n
        -c - ignore clipping warning when applying gain
        -o - output is a database-friendly tab-delimited list
        -t - mp3gain writes modified mp3 to temp file, then deletes original
             instead of modifying bytes in original file
        -q - Quiet mode: no status messages
        -p - Preserve original file timestamp
        -x - Only find max. amplitude of mp3
        -f - Force mp3gain to assume input file is an MPEG 2 Layer III file
             (i.e. don't check for mis-named Layer I or Layer II files)
        -? or -h - show this message
        -s c - only check stored tag info (no other processing)
        -s d - delete stored tag info (no other processing)
        -s s - skip (ignore) stored tag info (do not read or write tags)
        -s r - force re-calculation (do not read tag info)
        -u - undo changes made by mp3gain (based on stored tag info)
        -w - "wrap" gain change if gain+change > 255 or gain+change < 0
              (use "-? wrap" switch for a complete explanation)
If you specify -r and -a, only the second one will work
If you do not specify -c, the program will stop and ask before
     applying gain change to a file that might clip
