
						  CuSeeMe/2 Support
						  =================

General:
--------

There are two PlugIn modules for CuSeeMe/2, all of which support B&W
and Colour cameras.

1) QVCUSOLO.DLL - A StandAlone plugin which only requires the supplied
device-driver and support DLLs to be available.

This has the advantage that it does nothing until CuSeeMe/2 requests
a picture. The CuSeeMe/2 Setup dialog on the Local Video window
provides support for adjusting camera controls. Where a colour camera
is detected a thumbnail picture is displayed in colour to enable
camera settings to be set accurately.

2) QVCUGREY.DLL - A StandAlone plugin which only requires the supplied
device-driver and support DLLs to be available.

This is identical to QVCUSOLO.DLL with the exception that it always
transmits Greyscale images when a Colour camera is connected.


Installation:
-------------

Note that the installation routine for the QuickCam Viewer, QV2, must
be run to install the device-driver and set appropriate CONFIG.SYS
entries. A reboot will be required to make the changes effective.

Installing the PlugIns for use with CuSeeMe/2 is performed using the
CuSeeMe/2 PlugIn Centre.


Notes:
------

The low-light filter is automatically enabled when the brightness
reaches a value of 160 and cannot be disabled.

